Backing Up the Settings
109
Backing Up All Data to a USB
Flash Drive (SAVE)
Here’s how to back up the entire contents of user
memory (p. 16) to your USB ash drive (up to 99 sets).
1. Connect your USB ash drive to the TD-30’s USB
MEMORY port (p. 85).
2. Press the [USB MEM] button.
The [USB MEM] button will light, and the USB MEMORY A
screen will appear.
3. Press the [F1] (SAVE) button.
The USB SAVE screen will appear.
4. Use the [–] [+] buttons or the dial to select the
backup number in which you want to save your
settings.
Backup number that contain no data are indicated by a
"*" preceding the backup name.
MEMO
If you press the [F4] (NEW) button, the lowest-
numbered backup number that contains no data will
be selected.
5. Press the [F5] (SAVE) button.
A conrmation message will appear.
If you decide to cancel, press the [F1] (CANCEL) button.
MEMO
If you want to assign a name to the backup data,
press the [F4] (NAME) button.
6. Press the [F5] (EXECUTE) button.
Your data will be saved on the USB ash drive.
Naming your backup data (NAME)
If you want to assign a name to the backup data,
press the [F4] (NAME) button at the conrmation
message in step 5.
The USB SAVE NAME screen will appear.
For details on how to assign a name, refer to
“Assigning a Name” (p. 29).
The name you assign here is shown only on the
TD-30.
AppendicesExpansionSettingsPerformanceSetupOverview
To Next Page
Loading...
