Trigger Settings
137
Copying a Trigger Bank
You can copy a trigger bank from preset memory or from
a USB ash drive.
For user memory, you can rearrange the data by
exchanging the copy-source and copy-destination
trigger banks.
NOTE
When you execute the copy, the contents of the
copy-destination will be overwritten. If you want to
keep those settings, back them up to a USB ash drive
before you continue (“Backing Up the Settings” (p. 108)).
1. Hold down the [SHIFT] button and press the
[USB MEM] button.
[USB MEM] button will light, and the COPY A screen will
appear.
2. Press the [F5] (A B C) button twice to access the
COPY C screen.
3. Press the [F1] (TRIG) button.
The COPY TRIGGER BANK screen will appear.
Copy-source
Copy-destination
4. Use the [F1]–[F3] buttons to select the copy-
source.
Button Explanation
[F1] (USER) button
Copy from user memory.
Exchanging the copy-source and
copy-destination is possible only if
the copy-source is user memory.
[F2] (PRESET) button Copy from preset memory.
[F5] (USB) button
Copy from backup data saved on a
USB ash drive
5. Use the cursor buttons, [–] [+] buttons, and dial
to specify the copy-source and copy-destination.
If you selected [F3] (USB) in step 4, select the copy-source
backup number.
6. Press the [F4] (EXCHNG) or [F5] (COPY) button.
A conrmation message will appear.
(Example: Copying a trigger bank from a USB ash drive)
If you selected [F1] (USER) in step 4, you can exchange
the copy-source and copy-destination by pressing the
[F4] (EXCHNG) button.
Press the [F5] (COPY) button to execute the copy.
If you decide to cancel the copy or exchange, press the
[F1] (CANCEL) button.
7. Press the [F5] (EXECUTE) button.
The trigger bank will be copied.
AppendicesExpansionSettingsPerformanceSetupOverview
To Next Page
Loading...
