Basic Operation
28
Using The Group Faders (GROUP FADERS/[FADER] button)
Use the GROUP FADERS faders to adjust the volume.
By pressing the [FADER] button, the function of the faders changes
as shown in the chart below. An LED will light up at the upper and
lower left of the faders, indicating which set of sounds is active.
You can adjust the volume of following trigger inputs and the other kinds of volumes.
Upper indicator is lit Lower indicator is lit
Fader Explanation Fader Explanation
KICK KICK AUX 1 AUX 1
SNARE SNARE AUX 2 AUX 2
TOMS TOM 1, TOM 2, TOM 3, TOM 4 AUX 3 AUX 3
HI-HAT HI-HAT AUX 4 AUX 4
CRASH 1 CRASH 1, CRASH 2 CLICK Metronome click (p. 82)
RIDE RIDE, EDGE PATTERN Pattern (backing part and percussion part) (p. 89)
AUX All AUX USB SONG Audio le (p. 86)
AMBIENCE AMBIENCE AMBIENCE AMBIENCE
MEMO
The GROUP FADERS temporarily adjust the overall balance of the TD-30.
By using the mixer (p. 65) you can adjust the volume balance of the pads for each kit. Mixer settings are saved individually for
each kit.
Example: Adjusting the Snare Volume
1. Press the [FADER] button so the upper indicator is lit.
2. Move the GROUP FADERS [SNARE] fader.
The fader position shows the current snare volume.
* After switching with the [FADER] button, the values for the GROUP FADERS faders may not reect the actual volume of the
sound assigned to that fader. So after switching, be sure to move the faders a bit before making your setting.
Turning the Click On/O
Hold down the [SHIFT] button and press the [TEMPO] button to turn the click on and o.
Changing the Tempo ([TEMPO] button)
To adjust the tempo of the sequencer and click, use the [–]
[+] buttons or the dial in the screen displayed by pressing the
[TEMPO] button.
To Next Page
Loading...
