Roland V-Drums TD-30 - Setting Volume and Pan for Each Part (Mixer)

Pattern Sequencer
96
Setting the Volume and Pan of
Each Part (MIXER)
Set the volume and pan for each part.
MEMO
• Drum part cannot be set here. Set in the MIXER
settings (p. 65).
• To adjust volume/pan settings for each instrument in
the PERCUSSION SET EDIT screen.
1. In the PATTERN PART screen (p. 91), press the [F4]
(MIXER) button.
The PART VOLUME, PART PAN, PART REVERB SEND LEVEL,
or PART CHORUS SEND LEVEL screen will appear.
2. Press the [F1]–[F4] buttons to select the
parameter.
3. Use the cursor [ ] [ ] buttons to select the part
you wish to set.
4. Use the dial, the [–] [+], or cursor [ ] [ ] buttons
to make settings.
Parameter Value Explanation
[F1] (VOLUME) button
PART VOLUME 0–127
Volume of each part
The percussion part
(PERC) species the
volume of the entire part.
[F2] (PAN) button
PART PAN L15–CTR–R15 Panning of each part
[F3] (REV SND) button
PART REVERB
SEND
0–127 Reverb depth of each part
[F4] (CHO SND) button
PART CHORUS
SEND
0–127 Chorus depth of each part
5. Press the [EXIT] button to return to the PATTERN
PART screen.
Applying Reverb/Chorus to the
Backing Parts (REV/CHO)
Set the amount of reverb and chorus for each backing
part.
1. In the PATTERN PART screen (p. 91), press the
[F5] (REV/CHO) button.
The REVERB/CHORUS screen will appear.
2. Press the [F2]–[F4] buttons to select the
parameter.
3. Use the cursor buttons to select the parameter.
4. Use the [–] [+] buttons or the dial to make
settings.
Parameter Value Explanation
[F2] (REV/CHO) button
REVERB
Type
AMBIENCE,
ROOM,
HALL,
PLATE
Type of reverb
Time 0–127 Reverb length/delay time
CHORUS
Rate 1–64 Speed of modulation
Depth 1–64 Depth of modulation
[F3] (REV SND) button
PART REVERB
SEND
0–127
Amount of reverb applied
to each part
[F4] (CHO SND) button
PART CHORUS
SEND
0–127
Amount of chorus applied
to each part