Roland V-Drums TD-50 - TRIG MONITOR (Page 3)

26
TRIGGER
Parameter Value Explanation
POSITION tab
Trig Type This is the same parameter as Trig Type (p. 22) in the BANK tab.
Position Detect*2
Positional sensing on/o
If you turn strike position detection on, you’ll be able to produce tonal change by varying the strike position on the head or by changing
the nuance of your rim shots.
Head OFF, ON Turns head strike position detection on/o
Rim OFF, ON Turns rim strike position detection on/o
*1 Only when Trig Type is set to “RT30K” or “RT30HR”
*2 For some Trig Type settings, this cannot be specied.
MEMO
To return to the default values, press the [F5] (DEFAULT) button.
The following parameters do not return to their default values when you change the Trig Type or press the [F5] (DEFAULT) button.
5 Hi-hat parameters
5 Oset
5 Foot Splash Sens
5 Noise Cancel
5 CC MAX
5 XStick Threshold
5 XTalk Cancel Rate
TRIG MONITOR (page 3)
Parameter Value Explanation
XTALK tab
XTalk Cancel Rate 0–80
Strength of crosstalk cancellation
Reference
For details on how to make these settings, refer to “Reference Manual.”