Roland V-Mixer VM-3100 - Page 13

CH VIEW
ineereeoe ES JAUX O@
| Fricaghei-< Qo
FHIGDSIMOS-6 OF
FRZCvAIIL O[DautE
- INPUT FADER
bleed Ht
PPRSHYSETADMi L-R
- OUTPUT FADER
Ct
Seer,
AFUT IE) Ewe CON WIE Mile HH
Hold down the SHIFT key and press a CURSOR button
to select the next page of a screen.
You can also turn the screen function buttons on and off
by pressing the [F1-F4 ON/OFF] buttons. When a
function is indicated, you can then select that function by
pressing the [F1]-[F4] buttons.
SYSTEM Button
SYSTEM
C
Press this button to make settings and changes to the
system.
5S EFFECTS
* This figure shows the VM-3100Pro.
EFFECTS Buttons
EFFECTS! EFFECTS&2 EFFECTS!
(VM-3100 Pro) (VM-3100)
Use these buttons to select the internal effects screen. On
the VM-3100, only EFFECT 1 can be selected; on the
VM-3100Pro, EFFECT 1 and EFFECT 2 can be selected.
COMPRESSOR Buttons
EFFECTS! EFFECTS?
(J (vm-3100 Pro)
COMP1;2
(VM-3100)
Use this button to display the compressor settings
screen. Once the compressor screen is displayed, this
button can turn the internal compressor on and off.
PATCH SELECT Button
PATCH
SELECT
C3
This switches among the effects types indicated on the
effects section of the front panel. When the button is
pressed, the light by the name of the selected effect is lit.
Effect LEVEL Knob
LEVEL
Use this knob to adjust the output of the selected effect.
6 EZ ROUTING Button
Use this button to display the EZ Routing screen. This
function lets you set up and recall internal routings for
input and output signals.
7 VALUE Knobs
Use Volume to adjust the settings for each channel,
including effects and PAN settings.
8 BUS ASSIGN Button
PARAM Mev
This button allows you to specify the channel signals
sent to the BUS OUT jacks, etc.
13
USING THE UNIT SAFELY
IMPORTANT NOTES elo.
8
oe
o
a
a
a
os
=
>
@
te
=
8
w
<
=
V-Mixing Statlon?
Part Names
Trying Out the VM-3100
Digital Mixer Workbook
ty
a
2
S
=
DQ
o
a.
<