Roland V-Mixer VM-3100 - Page 14

9 Equalizer (EQ)
Use the equalizer knobs to boost or cut the high,
midrange, and low frequencies. Equalization for each
channel can be set individually.
10 MONITOR Buttons
DIGITAL IN Button
Press this button to route the signal from the DIGITAL
IN directly to MONITOR.
SOURCE Button
Press this button to route the monitor source signal to
MONITOR.
MONITOR LEVEL Knob
Use this knob to adjust the volume level of the signal
output to MONITOR.
11 PAN Button
(PAN)
Use the PAN button to adjust the left-right distribution
of a channel's signal. The initial settings of each channel
have the signals centered. The channel pairs 9-10 and
11-12 are hard panned to the left and right respectively.
12 AUX SEND Button
eT)
| TE
Press this button to select the AUX SEND screen. Here
14
you select the information to send, and the send level of
the signals sent, ta the AUX SEND jack from each
channel. Items that can be adjusted include EFFECT 1,
EFFECT 2 (VM-3100Pro only), and AUX MONAURAL
OUT 1 and 2 (factory settings).
13 VALUE Dial
Use the Value Dial to make changes to parameter values.
14 ENTER/YES, EXIT/NO Buttons
ENTER/YES Button
ENTERIYES
Use these buttons to respond to a Yes/No question or to
execute a specific function.
EXIT/NO Button
EXITNO:
Use this button to undo adjusted values or parameters.
15 CURSOR Buttons
om)
3 oc
ae) pa)
Cc
Use these buttons to move the screen cursor to the
desired parameter. Use these buttons in conjunction with
the SHIFT button to select different parameter screens.
16 SHIFT Button
Holding down the SHIFT button while pressing a panel
button executes the function indicated within the box
printed on that button.