Roland VersaCamm SP-540i - Media Handling and Jamming Issues; Print Head Movement and Error Messages

117
The Media Jams
If an error message is displayed because the media
has jammed, immediately correct the problem. Failure
to do so may damage the print heads.
 P. 122, [MOTOR ERROR TURN POWER OFF]
Is the media warped or wrinkled?
Many factors can cause warping or wrinkling. Refer to the fol-
lowing and correct the problem.
 P. 118, "Media Wrinkles or Shrinks, or Feed Is Unstable"
Is the height of the print heads too low?
Try raising the heads higher. Media may inevitably warp or
wrinkle slightly, so adjust the height of the heads to take this
into account.
 P. 72, "Adjusting Head Height to Match Media Thickness (54-inch
Model Only)"
5
What to Do If
5-3 The Media Jams