Roland VersaCamm VS-640i - Page 259

6-13
Message for Ink Circulation
White ink and metallic silver ink are circulated periodically to prevent the ink precipitation automatically.
!! IMPORTANT !!
The accuracy of Dual-pass Printing (Printing after pull-back the printing) is not specied.
The default media profiles in VersaWorks do not provide any Dual-pass print mode such as [-onWhite] or
[-underWhite].
Adding Media Proles
Explain the procedure of adding Media Proles of third-party media.
Downloading Media Proles from the web site.
Adding Media Proles to VersaWorks.
!! IMPORTANT !!
In the print mode for Mt ink, the ink may not dry fully depending on the type of the media. Conrm the proper
printing result in a trial printing beforehand.
Job outputting from
Roland VersaWorks
Explain each procedure as follows on a job outputting from Roland VersaWorks.
Printing
Cutting
Printing and cutting
Print then Cutting with Crop Marks (Refer to User's Manual [Printing with Crop Marks])
- Aligning Automatically and Cutting
- Aligning Manually and Cutting
!! IMPORTANT !!
Never use the Media clamps during cutting.
When printing and cutting are performed using Crop Marks, misalignment of cutting caused by media stretch/
shrinkage can be avoided.