22
ECO-SOL MAX 3 Ink Switching Method
When Operations Are Interrupted
Actions When the Cleaning/Wiper Replacement Operation Is Interrupted
STEP 5: Cleaning of the Periphery of the Print Heads (Manual Cleaning)
STEP 6: Replacing the Wiper and Felt Wiper
If you interrupt the above operations partway through the procedure, you cannot continue the operations with the proce-
dures in this manual.
The subsequent work to perform varies depending on the point when the operations were interrupted. Refer to the follow-
ing sections, and then perform operations according to the corresponding page of the user's manual of the model that you
are using.
Operations that must be performed
The following are the section titles in the table of contents of the user's manual (Chapter 3 Maintenance).
When the interruption occurs
during cleaning the periphery
of the print heads
(P. 12)
Manual Cleaning of
Print Head
Replacing the
Wiper
Replacing the Felt
Wiper
When the interruption occurs
during wiper replacement
(P. 13)
Replacing the
Wiper
Replacing the Felt
Wiper
When the interruption occurs
during felt wiper replacement
(P. 13)
Replacing the Felt
Wiper
If you do not perform all the operations, color mixing between the MAX ink and MAX 3 ink will occur. If you interrupt operations
partway through the procedure, be sure to perform the remaining operations from the point the procedure was interrupted.
To Next Page
Loading...
