Roland VersaStudio BN-20 - Preparation before Operations; STEP 1: Checking the Package Contents; STEP 2: Checking the Necessary Files; STEP 3: Writing a Memo with the Versaworks Settings

4
ECO-SOL MAX 3 Ink Switching Method
Preparation before Operations
STEP 1: Checking the Package Contents
This kit contains the following items. Make sure they are all present and accounted for.
Items used during ink switching
Cleaning sticks Tweezers (1) Gloves (1 set) Wiper (1)
Felt wiper (1) Drain cartridge (1)
Items used after ink switching (not used during ink switching)
Cleaning liquid (1)
(dedicated for use with MAX
3 ink)
STEP 2: Checking the Necessary Files
The les downloaded from http://www.rolanddg.com/ecosolmax3/ are necessary for the operations in this manual. Check
that the following les are present.
BN-20 driver
(In the "Driver" folder)
SETUP.EXE, SETUP64.EXE
* Found in a folder for the OS such as "WIN8X64."
Utility updater
(In the "Utility" folder)
Updater.exe
Ink switching tool
(In the "BN-20 MAX3 Ink Conversion Tool" folder)
BN-20_MAXtoMAX3.exe
Firmware
(In the "Firmware" folder)
BN20Firm250.exe
VersaWorks updater
(In the "Roland VersaWorks local updater" folder)
LocalUpdater.exe (Ver. 5.5.0 or later)
If the above les are not present, download them from the following URL.
http://www.rolanddg.com/ecosolmax3
STEP 3: Writing a Memo with the VersaWorks Settings
Important
As the nal step when you switch the ink, update VersaWorks to a version that supports MAX 3 ink. After the update, because
the printer that has been switched to MAX 3 ink will be connected as a new printer, the previous job data and settings will be
deleted. Before switching to MAX 3 ink, write down the IP address and the settings of the connected printer such as "Quality."