Roland VersaStudio BN-20 - STEP 3: Printing Tests and Normal Cleaning

Printing
STEP 3: Printing Tests and Normal Cleaning
Procedure

Open the Utility window.
 P. 7, "How to Open the Utility Window / Exit the Utility"

Click [Check Nozzle Condition].

Click [Test Print].
The test pattern is printed. Follow the on-screen
instructions and check for dot drop-out.
Nozzle clogging occurs  Proceed to  .
Nozzles are not clogged  Click [Close].

Select [Cleaning Normal] and click [Go].
Normal cleaning starts.

To check for nozzle clogging again  Return to  .
If the nozzle clogging is not xed, perform "Normal Cleaning" again. For information about "Medium
Cleaning" and "Powerful Cleaning," refer to page 74 "Medium and Powerful Cleaning."
Chapter 1 The Basics
21
Chapter 1 The Basics