Roland VersaStudio BN-20 - STEP 5: Starting Print Output

Printing
STEP 5: Starting Print Output
This section explains how to output from R-Works.
When outputting from Roland VersaWorks, refer to the "Roland VersaWorks Quick Start Guide" and the "BN-
20 Roland VersaWorks Metallic Silver Ink Guide". When outputting from commercially available application
software for creating drawings, refer to the documentation supplied with your application software.
Procedure

Start R-Works.
 P. 8, "How to Start R-Works"

Create a drawing.
Refer to "Step 1: Create a new project" and "Step 2: Create the print data" from [Operation Procedures] in
the R-Works Help, and create a drawing.
 P. 8, "How to Open the BN-20 Driver/R-Works Help"

Starting Output
Refer to "Step 4: Outputting" from [Procedure] in the R-Works Help.

Cut the media when outputting is com-
plete.
Use a commercially-available blade to cut the
media.
You can set time for the printer to wait before printing the next page (Dry Time) after output.
 P. 63, “Setting of Dry Time”
Chapter 1 The Basics
23
Chapter 1 The Basics