The cutting conditions and the service life of the blade change according to the media and the operat-
ing environment, even when you're using identical blades. The service life also differs according to the
type of blade. A rough guide is shown below.
Blade Media Blade force Amount of blade offset Blade life (general
guide)
*1
ZEC-U1005 General signage vinyl 50 to 150 gf 0.25 mm 8000 m
ZEC-U5025 General signage vinyl
Fluorescent vinyl
Reflective vinyl
30 to 100 gf
120 to 200 gf
100 to 200 gf
0.25 mm
0.25 mm
0.25 mm
4000 m
4000 m
4000 m
*1 The values for "Blade life" are estimates for when an identical type of media is used.
MEMO
When uncut areas remain even when the blade force is increased to a value that is higher by 50 to 60 gf than the
values shown in this chart, then replace the blade.
About the Blade
Main Specifications 115
To Next Page
Loading...
