2. Creating print data
Procedure
1. Create the print data using application software for creating drawings.
MEMO
Set the Document Color Mode to [RGB]. The color (RGB value) specified as the cutting line may change be-
cause CMYK is converted to RGB when outputting in CMYK mode.
In this case, it may not be possible to perform cutting because the color specified for the driver as the cut-
ting line and the color output from the application software differ.
2. Specify the RGB value set for the part to be identified as the cutting line in step 1. - 4.
If the color for the part you want to print and the color set in step 1. - 4 overlap, redo the
settings from step 1. - 4.
3. Specify the line width for cutting lines as follows.
MEMO
It may not be possible to cut lines of the specified width.
• Adobe Illustrator : 0.001 pt
• CorelDRAW : Hairline
Cutting / Printing and Cutting
44 Optimizing the Output Quality
To Next Page
Loading...
