To Perform Printing and Cutting Separately
You can remove the printed media and then reload it and perform cutting.
(Example: Perform lamination or other processing after printing, then reload the media and perform
cutting.)
Then, carry out alignment to prevent misalignment of the printing results and the cut lines. Perform
this adjustment in the next Procedure.
Procedure
1. Printing with Crop Marks.
P. 47 "Printing with Crop Marks"
2. Align to the printed crop marks and perform cutting.
P. 49 "Aligning Automatically and Cutting"
Media Sizes Allowing Automatic Crop Mark Detection
Pinch roller
Crop Mark
A 65 mm or more
B 22.5 mm
C 1.4 mm
D 60 mm or more
Performing Printing and Cutting Separately
46 Optimizing the Output Quality
To Next Page
Loading...
