Roland VersaSTUDIO BN-20A - Utility: Other Function; Performing Various Adjustments through a Sequence of Operations

Performing Various Adjustments Through a Sequence of Operations
You can perform various output adjustments through a sequence of operations by clicking [Adjust All]
on the [Adjustment] tab. The adjustment method is the same as when adjusting settings individually.
When you click [Adjust All], adjustment information is displayed.
[Next] : Continues to the adjustment screen currently displayed on the screen.
[Skip] : Skips the adjustment currently displayed on the screen.
[Cancel] : Cancels the adjustment process.
The adjustments vary depending on the output method. Refer to the table below.
Print (Only)
Cutting (Only) Printing and Cutting Crop Cut
Check Nozzle Condition ○ - ○ ○
Bidirectonal adjust-
ment
*1
○ - ○ ○
Calibrate Sheet Feed
Amount
○ ○ ○ ○
Cut Adjustment - ○ ○ ○
Print Cut Adjustment - - ○ ○
CropCut Adjusutment - - - ○
*1 This is available when bidirectional printing is set in the BN-20 driver or VersaWorks.
Utility : Other Function
52 Optimizing the Output Quality