Are two or more machines connected to a single computer?
The utility cannot control more than one machine at the same time. Never connect two or more in-
stances of this machine to a single computer.
Is the temperature of the room too low?
This machine does not complete startup until the heater reaches the specified temperature, and does
not accept any operation. When the ambient temperature is low, the heater is slow to warm up. Use
the machine in an environment where the temperature is 20 to 32 °C (68 to 90 °F).
Did you forcibly remove any detachable external storage device connected by
USB?
When you remove the USB removable device (USB flash drive or USB hard disk etc.), you must run
[Safely Remove Hardware and Eject Media] or [Eject] before detaching it. If you remove the USB de-
vice without it in process of printing, the printing may be aborted.
The Printer Unit Doesn't Run
Machine Problems 95
To Next Page
Loading...
