Roland VersaStudio BT-12 - Replacing an Ink Collector Unit; Checking the Waste Ink Level

166
8.Maintenance
ReplacinganInkCollectorUnit
CheckingtheWasteInkLevel
FollowtheprocedurebelowtocheckwhentoreplaceaninkcollectorunitusingtheStatus
Monitororthewasteinkfullindicator.
Checkingthewasteinklevelonthedisplay
Youcancheckthewasteinklevelbylookingattheiconthatappearsabovethewasteinkfull
indicator.
CHU124

Iftheinkcollectorunitisalmostfull,themessage"PreparenewInkCollectorUnit"appearson
thedisplay.
Makesureyouhaveanewinkcollectoronhand.
Iftheinkcollectorunitisfull,themessage"InkCollectorUnitisfull/ReplaceInkCollectorUnit"
appearsonthedisplay.
Replacetheinkcollectorunit.
CheckingthewasteinklevelontheStatusMonitor
Theinkcollectorunitstatuscanbeusedtocheckwhentoreplacetheinkcollectorunit.