Roland VersaStudio BT-12 - Page 192

190
9.Troubleshooting
DYX035
1
1

1. Sensor
2.
Pressthe[Start]key.
Printingstarts.
Ifprintingdoesnotstart,repeatSteps1and2untiltheheightbecomesappropriatefor
printing.
Adjustingtheheightofthetrayautomatically

• Remove the garmentfrom thetray before performing autoadjustment. Donot perform
autoadjustmentwhilethegarmentisonthetray.
• When you perform auto adjustment, the height of the tray is adjusted appropriately
accordingtothetraythatisset.Performautoadjustmentagaineverytimeadifferenttray
isset.
• Whenyouperformautoadjustment,theheightofthetrayisadjustedsoitissuitablefor
loadingthingarments,suchasT‐shirts.Whenloadingthickgarmentsinthetray,finetune
the height of the tray using the [Adjust Height ] key after sending the print job. For
details,seepage189"AdjustingtheHeightoftheTray".
When printing starts, the machine adjusts the height ofthe trayaccordingtotheheightvalue
specifiedinthe[Maintenance]menu.Iftheprintedimageisblurryorthereisduststucktoit,or
theheightofthetraymaynotbeadjustedappropriately,adjusttheheightofthetrayusingthe
[Maintenance] menu. This section explains how to adjust the height of the tray automatically
usingthe[Maintenance]menu.Fordetailsaboutadjusttheheightofthetraymanuallyusingthe
[Maintenance]menu,seepage191"Adjustingtheheightofthetraymanually".
1.
Loadthetraywithoutagarmentonit.
2.
Pressthe[ /Menu]key.
3.
Pressthe[ ]or[ /Menu]keytodisplay[Maintenance],andthenpressthe
[#Enter]key.
4.
Pressthe[ ]or[ /Menu]keytodisplay[HeightAdjust],andthenpressthe
[#Enter]key.
5.
Pressthe[ ]or[ /Menu]keytodisplay[AutoAdjust],andthenpressthe
[#Enter]key.