Roland VersaStudio BT-12 - Turning On;Off the Power

1.AboutThisProduct
22
TurningOn/OffthePower

• Whenyouturnthemachineoff,makesureyoupressandholddown the [Power]key.If
you unplug the Power cord from the wall outlet, ink consumptionformaintenance
operationsmayincrease.
Turningonthepower
1. Pressthe[Power]key.

Ifthemachinestartswarmingup,thepowerlampflashesandthe"Waiting..."messagewill
bedisplayed.
Ifthemachinebecomesprintable,thepowerlamplightsandthe"Ready"messagewillbe
displayed.
Turningoffthepower
1. Pressandholddownthe[Power]keyforonesecond.
Whenthemachineisinshutdownmode,the"Shuttingdown..."messageisdisplayed.
Whenthemachinestops,thepowerlampandthedisplayturnoff.

• Tocutelectricityconsumptioncompletely,pressthe[Power]keyforonesecond,andcheck
thatthepowerlampisturnedoff.Then,unplugthepowercordfromthewalloutlet.
• Whenswitchingofftheenergysavingpowerstrip(powerstripwithaswitch),besuretoturn
offthemachinebeforefollowingtheaboveprocedures.
• EnergySavermodeisavailableforthismachine.Ifyoudonotusethismachinefora
specifiedtimeafterturningiton,themachinewillbeinEnergySavermodeautomatically,
andelectricityconsumptionofthemachinewillbereduced.Tospecifyawaitperiodfor
EnergySavermodeinitiation,configurethesystemsettings.Seepage122"Usingthe
[System]Menu".
• IfthemachineisinEnergySavermode,thedisplayturnsoff.
• ThemachinerecoversfromEnergySavermodewhenitreceivesaprintjob,orwhen
anykeyispressed.

