Roland VersaStudio BT-12 - Connecting the Computer and Installing the Software (Network Connection); Connecting the Machine Via Ethernet Interface

45
ConnectingtheComputerandInstallingtheSoftware(NetworkConnection)
ConnectingtheComputerandInstallingthe
Software(NetworkConnection)
ConnectthemachinetothecomputerviaanEthernetcable.Then,configurethenetworksettings
inaccordancewiththenetworkenvironment.Finally,installtheprinterdriver.
ThisguideusesWindows7/10proceduresforitsexamples.Proceduresandscreensmightvary
dependingontheoperatingsystemyouareusing.
ConnectingtheMachineviaEthernetInterface
Besuretoinstallallnecessarynetworkequipment,suchashubs,etc.beforeconnectingthe
Ethernetcabletothemachine.
Youcanconnecta10BASE‐Tor100BASE‐TXcabletothemachine.

• Ethernetcablesarenotsuppliedwiththismachine.Selectyourcableaccording
tothenetworkenvironment.
1.
Opentheportcover.
DYX017

2.
PlugtheEthernetcableintotheport.
DYX020
