Roland VersaStudio BT-12 - Loading Fabrics; Loading a Fabric in the Standard Tray

58
2.PreparingforPrinting
LoadingFabrics
Thissectionexplainstheproceduresforloadingfabrics.


LoadingaFabricintheStandardTray
ThissectionexplainshowtoloadafabricintheA4standardtray.Thesameoperationapplies
whentheA5trayisused.

• Whenprintingonthinfabrics,theinkmayadheretothetable.Placepaperorsomething
similaronthetablebeforeloadingthefabric.
1.
Pressthe[Power]key.
Removethetrayafterturningthepoweron.Ifthetrayismistakenlyremovedbeforeturning
thepoweron,turnthepoweroffonce,andthenturnthepoweronagain.
2.
Checkthatthetraystandcomestothefront.
Ifthetraystanddoesnotcometothefront,pressthe[Tray]keyandmovethetraytothe
front.
3.
Liftthetrayslightly,pullittothefronttoremoveit.
4.
Presstheunlockbuttonandliftthecover.
DSA348

5.
Putmarksonthefabricforwhenloadingitinthetray.
Theimagewillbeprintedinthedirectionfromthefrontsidetothebacksideofthetray.
Turntheprotectioncoverinsideoutandputitonthefabricinthedirectionasshowninthe
figure,andthenuseapenwitherasableinktomakethemarksthroughtheholesinthe
protectivecover.
• Whenloadingorremovingfabrics,keepyourhandsorfingersclearofthetray.
Otherwise,yourhandsorfingersmightgetcaught,resultingininjury.