Roland VersaStudio BT-12 - Loading Socks in the Sleeve & Socks Tray

61
LoadingFabrics

9.
Afterclosingthecover,iftherearestillwrinklesorslackontheprintingsurfaceat
thecenterofthetable,pushbothendsofthetraylightlyandpushthefabric
underthetable.
Afterclosingthecover,checkthatthefabricisnotcaughtbetweenthecoverandthetray.
DSA048

DSA049

LoadingSocksintheSleeve&SocksTray
Whenyouwanttoprintonsocks,usetheSleeve&SocksTray.

• TouseSleeve&SocksTray,youneedtoinstallthelatestfirmware(ver.1.20orlater)on
themachine.
• Ifyouperformprintingwiththeedgesofthefabricstilloutsideofthetable,thefabricor
thismachinemightbedamaged.Afterfixingthefabric,makesurethatitfitswithinthe
widthofthetray.
• Donotforciblyliftortwistthetable.Doingsomaycauseafailure.
1.
Pressthe[Power]key,andthenturnonthemachine.
Detachthetrayafterturningonthemachine.Ifyoudetachthetraybeforeturningonthe
machine,turnitofffirst,andthenturnitonagain.
2.
Makesurethatthetraystandisoutofthemachine,andthendetachthetray.
Ifitisnotoutofthemachine,pressthe[Tray]keytoejectthetray.
• Liftupthetraylightlyandpullthetraytodetachit.
