Roland VK-8 - Important Safety Instructions; Electrical Safety and Wiring Precautions

®ÂØÒňÎ
®
VK-8
Combo Organ
TurboStart
TBS158 © 2002 Roland Corporation U.S., 5100 S. Eastern Ave., Los Angeles CA 90040 Faxback # 20191 Page 2
Adding Vibrato or Chorus
Use the following procedure to add vibrato or chorus
to the current sound.
Note: Vibrato or chorus cannot be applied to
percussion sounds.
1. Press the button beneath VIBRATO AND
CHORUS so it’s lit.
2. Turn the VIBRATO AND CHORUS knob to
select the desired type of vibrato or the desired
type of chorus.
Note: Vibrato and chorus cannot be applied together.
Changing the Amp Type
The VK-8 offers a COSM-based virtual amplifier for a
vintage organ cabinet sound. Use the following
procedure to change the amp type and its
characteristics.
1. Press the button beneath AMPLIFIER to select
the desired type of virtual amp.
2. Turn the OVERDRIVE knob to dial in the amount
of distortion you want.
3. Turn the TONE knob to adjust the brightness of
the amp.