36
Playing the Organ
■ Adjusting the Sensitivity of the D Beam
Controller
The VK-8 automatically calibrates the sensitivity of the D Beam controller each time
power is turned on. You can also adjust the sensitivity of the D Beam controller after
the power is turned on.
Caution
The VK-8 automatically calibrates the sensitivity of the D Beam controller each time
power is turned on. For this reason, when turning on the power, make sure no object
is placed on the D Beam, and avoid having your hands near it.
Also, please be aware that the D Beam will not function in a location where there is
a large amount of infrared light.
Automatically adjusting the sensitivity of the D Beam controller
1 While holding down the D BEAM [ON] button, press the VIBRATO
AND CHORUS [ON] button.
The sensitivity of the D Beam controller will be adjusted automatically.
The D Beam indicators will show the D Beam sensitivity.
Manually adjusting the sensitivity of the D Beam controller
1 While holding down the D BEAM [ON] button, turn the [VIBRATO
AND CHORUS] knob to adjust the sensitivity of the D Beam controller.
Since the sensitivity of the D
Beam controller is adjusted
automatically when the power
is turned on, the sensitivity of
the D Beam controller is not
stored internally.
Min Max
To Next Page
Loading...
