Roland VR-09 - Selecting Synthesizer Sounds and Registrations; Selecting Synthesizer Sounds; Selecting Synthesizer Sound Variations; Selecting Your Favorite Sounds (Registration)

Selecting Sounds
10
Selecting Synthesizer Sounds
1. Press the MODE [SYNTH] button.
The MODE [SYNTH] button will light.
Volume
(SYNTH LEVEL [ ] [ ] button)
Octave (p. 17)
Sound
Sound variation
Multi-eect type (
&
PDF)
MEMO
Use the CURSOR [
] [ ] buttons to move the cursor to an item,
and turn the [VALUE] dial to change the sound variation/multi-
eect type.
Selecting the Synthesizer sound variation
1. Press one of the sound buttons in the synthesizer section.
2. Turn the [VALUE] dial to select the desired sound
variation.
MEMO
• You can play the keyboard to audition the sound at which the
cursor is located.
• If you press the [TRANSPOSE] button while the sound variation
select screen is shown, the select screen will be held. Press the
[EXIT] button to return to the previous screen.
Selecting Your Favorite Sounds
(Registration)
You can assign a name to your favorite organ, piano, and
synthesizer sounds (or combination of sounds), and store it as a
“registration.”
A registration can be recalled instantly by pressing a single button.
This is a convenient way to switch sounds for each song, or to
instantly switch between settings during a live performance.
Registrations are organized into banks, with 4 registrations in each
bank.
There are 25 banks, allowing you to store a total of 100 registrations.
1
Bank
4 registrations
=
Bank
2
3
4
25
MEMO
• When this unit is shipped from the factory, several banks contain
registrations with the same settings.
• Sets of registrations can be saved on a USB ash drive (p. 28).
• Sets of registrations saved on a USB ash drive can be loaded
back into this unit (p. 29).
Recalling a Registration
1. Press the [1]–[4] buttons to select a registration.
The registration screen is shown in the display.
Registration number
Bank number
Multi-eect type (
&
PDF)
Split or Dual setting (p. 18)
Registration name
Volume
Octave (p. 17)
MEMO
• You can select a registration by moving the cursor to the
registration number and turning the [VALUE] dial.
• You can select the next registration by pressing the [NEXT]
button.
• If registration 4 is selected, pressing the [NEXT] button will
select registration 1 of the next bank.