8
Sending the Messages to an External MIDI Device
If you are sending MIDI messages to an external MIDI device from the VR-3, set parameters as below.
COM : MIDI OUT
* Set this to [OUT].
COM : Tx CHANNEL
* Select the Tx channel.
You can send MIDI messages corresponding to the panel operations of the VR-3 as below.
• Controlling the volume of audio mixer 1-4, 5/6, 7/8 and internal mic.
• Controlling of the master and USB output volume.
• Selection of the video channel.
• Controlling of the output fade.
• Selection of the transition effect type.
• Adjustment of the transition time.
• Selection of the composition effect and turning On/Off.
• Adjustment of the key level.
• Turning On/Off of the freeze function.
* For corresponding MIDI messages, refer to “2. MIDI Messages Transmitted from MIDI OUT” (p. 18) in “MIDI Implementations”.
To Next Page
Loading...
