Roland VS-1680 - Page 17

Transport Control buttons
[SHIFT] + [STORE(ZERO)]: Store song data to the disk drive
[SHIFT] + [SONG TOP(REW)]: Move to the time where the first sound of the song is recorded
[SHIFT] + [SONG END(FF)]: Move to the time where the last sound of the song is recorded
[SHIFT] + [SHUT/EJECT(STOP)]: Shut down
[SHIFT] + [RESTART(PLAY)]: Restart (after shut down)
[REC] + STATUS buttons: Switch the status to REC (indicator blinks red)
[STOP] + STATUS buttons: Switch the status to PLAY(indicator lights green)
LOCATOR/SCENE buttons
[CLEAR] + LOCATOR buttons(1–8): Clear the setting of locators
[CLEAR] + [TAP]: Erase a marker
[SHIFT] + [CLEAR] + [TAP]’[YES]: Erase all markers
[BANK] + LOCATOR buttons(1–8): Switch the locator bank
[SCENE] + [TAP]: Execute snapshot (When Automix is “on”)
[SCENE] + [PREVIOUS]: Gradation to mixer setting of previous marker (when Automix is “on”)
[SCENE] + [NEXT]: Gradation to mixer setting of next marker (when Automix is “on”)
[SCENE] + [REC]: Automix Realtime recording (when Automix is “on.”)
[SHIFT] + [SCENE]: Transmit the condition of the digital mixer as MIDI data from MIDI OUT
connector
[SHIFT] + [START(1)]: Enter the current time as track edit start point. If it has been already set,
move to that time (except track condition).
[SHIFT] + [END(2)]: Enter the current time as track edit end point. If it has been already set,
move to that time (except track condition).
[SHIFT] + [FROM(3)]: Enter the current time as track edit from point. If it has been already set,
move to that time (except track condition).
[SHIFT] + [TO(4)]: Enter the current time as track edit to point. If it has been already set,
move to that time (except track condition).
[SHIFT] + [CLEAR] + [START(1)]: Clear the track edit start point (except track condition)
[SHIFT] + [CLEAR] + [END(2)]: Clear the track edit end point (except track condition)
[SHIFT] + [CLEAR] + [FROM(3)]: Clear the track edit from point (except track condition)
[SHIFT] + [CLEAR] + [TO(4)]: Clear the track edit to point (except track condition)
[SHIFT] + [PREVIOUS]: If there is a phrase on current time, move to the beginning of that phrase.
If not, move to the end of the previous phrase (when PREVIOUS/NEXT
Sw is “MARKER”). Move to the previous marker (when
PREVIOUS/NEXT Sw is “PHRASE”)
Special Key Operations
17