Roland VS-2400CD - Page 28

28
Parameter List
*1 Valid when Channel Link is “On.”
*2 If Channel Link is On, the “Pan” parameter will change to the offset pan parameter.
*3 Valid when Dynamics Type is “COMPRESSOR.”
*4 Max +6.0dB when compressor auto gain switch is “On.”
*5 Valid when Dynamics Type is “EXPANDER.”
*6 Changes in parameter settings accepted at any time. However, the settings are reflected in the outcome only when the
Equalizer Switch is “On.”
*7 Pre/Pst is switched at the same time by each bus in MASTER EDIT.
*8 Valid when AUX Switch is except “Off.”
*9 Valid when AUX Bus Link is “On.”
*10 “Off” or “Ins” are valid “Off” or “Ins” when Channel Link is “On.”
*11 Valid when Effect Insert Switch is except “Off.”
*12 Valid when Surround Mix Switch is “On.”
*13 Valid when Surround Mix Mode is except “2+2.”
*14 Valid when Surround Mix Mode is “3+2+1.”
*15 Valid when Pan Mode is “RSS.” Value changes as follows.
Value increase from 0: 0 → R3 → R6 → ... → R177 → 180 → L177 → L174 → ... → L3 → 0
Value decrees from 0: 0 → L3 → L6 → ... → L177 → 180 → R177 → R174 → ... → R3 → 0
Equalizer High Gain EQ High G -15.0– 0.0 –15.0 dB (*6)
Equalizer High Frequency EQ High F 1.0 kHz– 10.0 kHz –20.0 kHz (*6)
AUX Send Switch AUX (1–8) Off, Pre/ Pst (*7)
AUX Send Level -
- ∞ –+6.0 (*8)
AUX Send Pan - L63– 0 –R63 (*9)
Direct Path Switch DIR (1–8)
Off , On
Effect Insert Switch FX (1–4) Off , Ins, InsL, InsR, InsS (*10)
Effect Insert Send Level Snd - ∞ – 0.0 –6.0 dB (*11)
Effect Insert Return Level Rtn - ∞ – 0.0 –6.0 dB (*11)
Surround Pan SURROUND PAN L63– C –R63 (*12)
Surround Depth SURROUND DEPTH F63– C –R63 (*12)
Surround LR:C Rate SURROUND LR:C 0– 50 –100 % (*12) (*13)
Surround Sub Woofer Level SURROUND Sub.W - ∞ – 0.0 –+6.0 dB (*12) (*14)
Parameter name Display Value, Initial value
2400_app_e.book 28 ページ ２００５年４月２８日 木曜日 午後１時１４分