Roland VS-2400CD - Page 37

37
Parameter List
Parameter List
Oscillator/Analyzer [SHIFT]+[F4 (UTILITY)] → [(Page3) F4 (OscAna)]
Oscillator
*1 Metronome is not output to monitor when “METRONOME” is selected.
*2 Valid when Source is except “METRONOME.”
Analyzer
*1 When an effect board is being used by the analyzer, it’s unavailable for other use.
Parameter Initialize [SHIFT]+[F4 (UTILITY)] → [(Page3) F6 (PrmIni)]
R-BUS Configuration [SHIFT]+[F4 (UTILITY)] → [(Page4) F1 (R-BUS)]
R-BUS Configuration
[SHIFT]+[F4 (UTILITY)] → [(Page4) F1 (R-BUS)] → [F1 (R-BUS)] *1
*1 Valid when an R-BUS equipment is connected.
* The parameters appear on screen differs according to an R-BUS equipment connected to this unit.
Parameter name Display Value, Initial value
Switch Sw Off, On
Source SOURCE
PINK Noise , WhiteNoise, Sin Wave, METRONOME (*1)
Attenuator ATT -42.0– -12 –+0 dB (*2)
Fader Fader - ∞ – 0.0 –6.0 dB
Mix Send Pan PAN L63– C –R63
Mix Send Switch MIX
Off , On
AUX Send Switch AUX (1–8) Off, On
AUX Send Level
-
- ∞ –6.0 dB
Direct Path DIR (1–8) Off , On
Parameter name Display Value, Initial value
Source SOURCE IN1 –IN16, TR1–TR24, FX1–4 RTN L, FX1–4 RTN R, Gen/OSC, MST L, MST R,
MON L, MON R, AUX1–8, DIR1–8
Average Times AVERAGE TIMES 1 –128
Average Type AVERAGE TYPE Off, NRM , EXP
Use Effect Board Use EFFECT Board
Off , A, B (*1)
Parameter name Display Value, Initial value
Initialize Section INITIALIZE SECTION MIXER & UTILITY , MIXER, UTILITY
Parameter name Display Value, Initial value
R-BUS Remote Control R-BUS Remote Control Off , On
2400_app_e.book 37 ページ ２００５年４月２８日 木曜日 午後１時１４分