Roland VS-2400CD - Switching Automatically to Locator Mode; Locators in Safe Mode; Recalling a Locator in Safe Mode; Turning on Locator Safe Mode

13—Operating the Hard Disk Recorder
Roland VS-2400CD Owner’s Manual www.RolandUS.com 181
4. Press  or  or turn the Time/Value dial to select the desired locator. You can:
• press F1 (NAME) to rename (Page 71) the selected locator.
• press F2 (CLEAR) to delete the selected locator.
• press F3 (GetNow) to reset the locator to the now line’s current position.
• Press F4 (GO TO) to move the now line to the selected locator’s position.
5. Press F6 (EXIT) when you’re done to confirm your changes.
Switching Automatically to Locator Mode
You can set the VS-2400CD so that it remains in Scene mode after recalling and storing
scenes, or so it automatically returns to Locator mode after either action.
1. Hold down SHIFT and press F4•UTILITY.
2. If you don’t see “GLOBAL” above F2, press PAGE until you do.
3. Press F2 (GLOBAL).
4. If F1 (Param1) isn’t highlighted, press F1 (Param1).
5. You can set the RETURN TO LOCATE Sw parameter to:
• On —to automatically return to Locate mode after you store or recall a scene.
• Off —so that you return to Locate mode by manually pressing LOCATE.
6. Press F6 (EXIT) to confirm your changes.
Locators in Safe Mode
If you prefer to work with locators a bit more slowly and carefully, you can use Safe
mode. Safe mode allows you to work with locators in a LOCATOR window that shows
each locator’s number and name. You can also store and clear locators in Safe mode.
While this is a slower way to work, it provides greater certainty that you’ve got the right
locator.
Turning on Locator Safe Mode
1. Hold down SHIFT and press F4•UTILITY.
2. If “GLOBAL” doesn’t appear above F2, press PAGE until it does.
3. Press F2 (GLOBAL).
4. The UTILITY menu’s LOCATOR/SCENE TYPE parameter turns Safe mode on or
off—see Page 358. Its default value is Quick. To turn on Safe mode, select Safe.
Recalling a Locator in Safe Mode
1. Press LOCATOR—the LOCATOR window opens.
2. Turn the Time/Value dial to scroll through the list until
the desired locator is in view.
3. Enter the locator’s two-digit number on the keypad—
an arrow appears to the left of the locator in the list,
and “Locate? appears in the window.
4. Press ENTER/YES to recall the selected locator and close the window, or just press
ENTER/NO twice to leave the window without recalling a locator.
You can store a new locator at the now line’s current position by scrolling to an unused
locator line and pressing F3 (GetNow).
VS2400OMUS.book 181 ページ ２００６年２月２８日 火曜日 午前１１時１２分