Roland VS-2400CD - Setting up Pre or Post Track Direct Outputs

21—Working with the VS-2400CD 0utputs
Roland VS-2400CD Owner’s Manual www.RolandUS.com 275
Setting Up Pre or Post Track Direct Outputs
1. At the bottom right of the OUTPUT ASSIGN screen—see the previous
illustration—select the TRACK DIRECT SOURCE.
2. Turn the Time/Value dial to select:
• PreFader —so that track signals are sent to outputs unaffected by the positions of
their track channel faders.
• PostFader —so that the tracks’ track channel faders control their output levels.
VS2400OMUS.book 275 ページ ２００６年２月２８日 火曜日 午前１１時１２分