26—Mastering and CD-R/RW Operations
344 www.RolandUS.com Roland VS-2400CD Owner’s Manual
10. Select the desired WRITING METHOD: Track at Once or Disk at Once (see
Page 341).
11. Set Finalize (Page 341) as desired. You can set it to:
•
Off
—Use this setting when you’re burning audio on a Track at Once CD, and
you’ll to be adding more audio later.
•
On
—Use this setting when you’re burning a Disk at Once CD, or when you’re
adding the last selection to a Track at Once CD.
•
OnlyFin. (“Only Finalize”)
—Use this setting when you’ve decided you’re done
adding selections to a TAO CD, but haven’t yet finalized the CD.
12. Select the speed at which the burner is to write the CD. You can select any of the
available speeds—you’ll only be offered choices supported by your burner.
13. Press F5 (OK) to begin burning the CD.
The VS-2400CD asks if you’re sure you want to burn the disk with your current
settings, and if you’ve remembered to place the CD’s track markers:
Audio CD-R Write Sure?
(selected writing method)
CD Track No. OK?
14. If you wish to proceed, press ENTER/YES. To cancel the operation, press EXIT/NO.
15. The VS-2400CD displays a message about copyrighted material. When you’ve read
the message, press ENTER/YES, or press EXIT/NO to cancel the operation.
16. A screen appears that discusses licensing terms. If you agree to these terms, press
ENTER/YES to proceed. Otherwise, press EXIT/NO to cancel the operation.
If you press ENTER/YES, the VS-2400CD proceeds to burn the CD.
When it’s finished, the VS-2400CD asks if you’d like to burn another CD of the same
audio material. If you do, insert a new CD in your burner and press ENTER/YES, or
press EXIT/NO to complete your CD-burning session.
17. If you press EXIT/NO, the VS-2400CD displays “Done!”
Erasing a CD-RW Disk
• If you attempt to write to a CD-RW that already contains data, the VS-2400CD
displays:
Finalized Disc!
or
Not Blank CD!
• Press ENTER/YES to proceed. The VS-2400CD then displays:
CD-RW (ReWritable)!!
Erase?
All Data on the CD-RW
will be Erased.
Are You Sure?
• Press ENTER/YES to erase the current contents of the CD-RW disk. The erasing
procedure takes a few moments.
• Once the disk’s been erased, the VS-2400CD shows the same message as in Step 5
on Page 343. Press ENTER/YES to proceed or EXIT/NO to cancel.
• Finally, the VS-2400CD asks if you’re sure you want to proceed, as in Step 13 above.
Press ENTER/YES to proceed, or EXIT/NO to cancel the operation.
If you select Track at Once, make sure to use a CD-R disk. You can’t write a Track at
Once CD-RW disk.
Try using the highest available speed to make the burning operation as brief as
possible. If you have trouble burning the CD, try a lower speed.
VS2400OMUS.book 344 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
