26—Mastering and CD-R/RW Operations
Roland VS-2400CD Owner’s Manual www.RolandUS.com 345
If You Encounter Error Messages During CD Burning
The two error messages you’re most likely to see during CD burning are the following:
•
Please Insert CD-R Disc!
—If you see this message, there’s no CD-R or CD-RW disk in
the burner, the burner’s tray isn’t closed, or the burner’s not ready for use.
•
Not 44.1kHz Project!
—If you see this, the tracks you’re trying to burn to the CD are
not recorded at the required 44.1kHz sample rate.
The
VS-2400CD Appendices
contain explanations of additional error messages.
The CD Player Feature
You can use your CD-R/RW drive as a CD player that can play CDs that haven’t yet
been finalized. It can also play any finalized CD, as well as commercial CD releases.
When you’re using the CD Player feature, you can listen through the VS-2400CD’s
MASTER and MONITOR outputs, as well as the PHONES jacks. The CD Player feature
is for listening only—you can’t route audio from the CD to tracks for recording, or to
additional VS-2400CD output jacks or connectors.
Playing an Audio CD
1. Press CD-RW/MASTERING.
2. Press F3 (CDPlyr)—the CD PLAYER screen appears.
3. Insert the desired CD into the drive.
When you’re listening to a CD that hasn’t yet been finalized, you won’t be able to hear
approximately the final 0.5 seconds of each track.
To: Press:
Play the CD from your current location PLAY
Halt playback at the current position STOP
Rewind to the top of the CD ZERO
Jump to the start of the next track NEXT
Jump to the beginning of the previous track PREVIOUS
Eject the CD F3 (EJECT)
Turn off the CD Player feature F6 (EXIT)
When the CD’s not playing, you can use the VS-2400CD’s REW or FF buttons to change
your current location on the CD.
Track list
Disk info
Drive info
Current
location
Level meter
VS2400OMUS.book 345 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
