Roland VS-2400CD - 29 Using a VGA Monitor: Overview; About Chapters 29-35; The Main Display and the Info Display; Setting the Operation Target

Roland VS-2400CD Owner’s Manual www.RolandUS.com 381
29—Using a VGA Monitor: Overview
About Chapters 29-35
The remaining chapters describe how to use a color VGA monitor (purchased
separately) with your VS-2400CD. When the VGA is selected as your main display, you
can perform almost every VS-2400CD operation on the VGA using your mouse. These
operations have already been explained in detail in Chapters 1-28. Therefore, in the
following chapters we’ll point you to the relevant page or pages to avoid repetition.
We’ll do this in one of two ways:
The Main Display and the Info Display
Whenever an external VGA monitor is connected, the VS-2400CD provides a main
display and an Info Display. The:
• main display —is where you work. Interact with the main display using your mouse,
keyboard and the VS-2400CD’s top-panel controls. All messages appear here.
• Info Display —is a non-interactive screen that provides helpful supplemental
information. See Page 384 to learn how to set the contents of the Info Display.
You can select the VGA display or the LCD display as the main display, but not both at
the same time. When you select the main display—by setting the OPERATION
TARGET parameter—the other display is automatically designated as the Info Display.
Setting the Operation Target
You can toggle between the two OPERATION TARGET settings—
VGA or LCD—by holding down SHIFT and pressing the LCD ↔ VGA
button. Each time you reset the OPERATION TARGET, the
previously selected main display confirms the change.
Manually Setting the OPERATION TARGET Parameter
1. Hold down SHIFT and press F4•UTILITY.
2. If “SYSTEM” isn’t visible above F1, press PAGE until it is.
3. Press F1 (SYSTEM).
4. Press F2 (Param2) and locate the OPERATION TARGET parameter.
• When groups of items are presented in lists, the pages on which
they’re explained will be shown at their right.
• In other cases, we’ll use the double-arrow symbol shown here. In
this example, we’d be directing you to Page 123.
The VS-2400CD displays the currently selected operation target when it powers up.
Page 123
+
The internal LCD shows: The external VGA shows:
VS2400OMUS.book 381 ページ ２００６年２月２８日 火曜日 午前１１時１２分