31—VGA Main Display Home Screen
Roland VS-2400CD Owner’s Manual www.RolandUS.com 405
16. EQ Switch and Overview
17. DIR (DIRECT) 1-8 Selector
18. MIX Button
19. AUX Send Controls
The AUX send controls include the following parameters:
•
Send level
—drag a slider to set the track channel’s Aux send level to the
corresponding Aux bus (See Page 148). The send level appears to the right of the
slider in dB. When Aux busses are linked, the even-numbered bus’s send control is
replaced by a panning handle, described on Page 425.
•
Send status
—turns the Aux send to each bus on or off. See Page 148.
•
Pre/post switch
—sets the pre or post configuration of each Aux bus. See Page 81.
The color of each Aux bus’s slider provides helpful information at a glance. When a
slider’s:
•
blue
—the send is turned on and the bus is set to Post.
•
red
—the send is turned on and the bus is set to Pre.
•
gray
—the send is turned off.
When odd/even Aux busses are linked, the even-numbered bus’s slider is replaced by a
panning handle, as described on Page 425.
Turn on the track channel’s EQ by clicking the EQ switch. The
current EQ curve appears to the right of the switch—when the
switch is on, the curve turns blue.
You can set up a channel’s EQ by drawing the desired curve with your mouse in the CH
VIEW screen, as described on Page 417.
To assign the track channel to a Direct path, click the desired Direct
path’s number so it lights.
Turn MIX on to send the track channel’s signal into the MASTER
bus, the main stereo mix. Turn it off to remove it from the mix.
When you change an Aux bus’s pre/post setting, you’re setting the pre/post
configuration of the Aux bus for any channel that’s using it, as described on Page 148.
Send level
Send status
Pre/post switch
VS2400OMUS.book 405 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
