Roland VS-2400CD - FX Return Channel Parameter Strip; Input and Track Channel CH VIEW Elements; Track;V-Track Info

32—VGA Main Display CH VIEW Screens
416 www.RolandUS.com Roland VS-2400CD Owner’s Manual
8. FDRLINK Button
9. AUTOMIX STATUS Button
FX Return Channel Parameter Strip
1. Channel Name
2. ASSIGN Selector
3. GROUP Selector
4. MONO Switch
5. AUTOMIX STATUS Button
Input and Track Channel CH VIEW Elements
Track/V-Track Info
Click FDRLINK—so it’s lit—to link the current channel’s fader to its
odd/even partner so their levels can be set by moving either fader
while their other parameters remain independently controllable.
Click the AUTOMIX STATUS button repeatedly to set the channel’s
status as desired when Automix mode is on.
As shipped from the factory, each Aux bus is routed to
the input of its same-numbered effect processor. To
route a different Aux bus or a Direct path to the FX
return channel’s processor, click ASSIGN and select
the desired bus from the pop-up menu.
You can also do this by dragging the routing nodes in the LOOP
FX ASSIGN area of the screen, described on Page 420.
To assign the channel to a fader group, click GROUP
and select the desired group from the pop-up menu.
By default, the output of an effect processor is stereo. To collapse its left
and right sides to a mono signal, click MONO so it lights.
Click the AUTOMIX STATUS button repeatedly to set the channel’s
status as desired when Automix mode is on.
151
318
2.
1.
5.
4.
3.
224
224
224
318
Track and V-Track info for a standard input or track channel
Track and V-Track info for linked input or track channel
The symbols in
the V-Track area
are described on
Page 403.
VS2400OMUS.book 416 ページ ２００６年２月２８日 火曜日 午前１１時１２分