Roland VS-2400CD - Input Mixer;Master Block View; Input Channel Strips

33—VGA Main Display Mixer Views
Roland VS-2400CD Owner’s Manual www.RolandUS.com 423
Input Mixer/Master Block View
Select INPUT MIXER/MASTER BLOCK from the MIXER menu to view all of the
VS-2400CD’s 16 input channel strips and MASTER BLOCK settings at once on the
VGA.
Input Channel Strips
1. DYNAMICS (DYN) On/Off
2. EQ On/Off
3. AUX Send Sliders
4. MUTE (M) Button
5. SOLO (S) Button
Click this button to turn the channel’s dynamics processor on—so the
button’s lit—or off. See Page 149.
To turn the channel’s EQ on or off, click this button. When it’s lit, the
EQ’s on. See Page 149.
Set the amount of the channel’s signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus’s slider (Page 425).
To mute the channel, click this button so it’s lit. To un-mute the channel,
click the button again.
To solo the channel, click the SOLO button to light it. To un-solo the
channel, click the button again.
Master BlockInput Mixer
FADER
button
indicator
1.
2.
3.
5.
7.
8.
9.
4.
6.
148
138
138
VS2400OMUS.book 423 ページ ２００６年２月２８日 火曜日 午前１１時１２分