Roland VS-2400CD - FX Return Channel Strips

33—VGA Main Display Mixer Views
Roland VS-2400CD Owner’s Manual www.RolandUS.com 427
10. LINK Switch
FX Return Channel Strips
1. ASSIGN Button
2. Algorithm View Button
3. AUX Send Sliders
4. MUTE (M) Button
5. SOLO (S) Button
6. AUTOMIX STATUS (A) Button
7. BAL (Balance) Knob
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of “LINK” and select the desired type of linking from the
pop-up menu, or turn off linking. The LINK switch occupies the
combined lower edge of both of the channels it controls.
To designate an Aux bus as the send assigned to the
channel’s effect processor, click this button and select
the desired bus from the pop-up menu.
This button shows the name of the channel’s processor
and its currently selected effect patch. Click the button
to display the Algorithm View screen from which you
can select a new patch or edit the current patch.
Set the amount of the channel’s signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus’s slider (Page 425).
To mute the channel, click this button so it’s lit. To un-mute the channel,
click the button again.
To solo the channel, click the SOLO button to light it. To un-solo the
channel, click the button again.
When Automix is turned on, repeatedly click the AUTOMIX STATUS
button to set the channel’s Automix status.
Set the stereo position of the channel in the main MASTER bus mix by
dragging the BAL knob up or down as desired.
147, 151
1.
2.
3.
5.
7.
8.
9.
4.
6.
224
215
226
138
138
318
225
VS2400OMUS.book 427 ページ ２００６年２月２８日 火曜日 午前１１時１２分