Supplemental Information
448 www.RolandUS.com Roland VS-2400CD Owner’s Manual
DIGITAL OUT TYPE
This parameter selects the type of digital audio signals to be output from the
AE-7000. You can select:
•
TYPE1
—to produce digital audio that conforms to AES/EBU standards for use by
professional broadcast and recording studios. Use this setting if you wish to send
digital audio from the VS-2400CD to a ProTools™ system.
•
TYPE2
—to produce IEC 60958 digital audio for devices such as DAT and MiniDisc
recorders.
COPY PROTECT
When COPY PROTECT is on, SCMS copy-protection is embedded in IEC 60958 digital
audio transmitted from the AE-7000—to transmit this type of audio, TYPE2 must be
selected as the DIGITAL OUT TYPE (see above). This copy-protection prevents the
creation of further copies of the digital audio. To disable copy-protection, turn COPY
PROTECT off.
VSR-880 Settings
CH STATUS 1-8
You can set the status of each track on an R-BUS-connected VSR-880. You can choose:
•
SRC
—to listen to the track’s source signal.
•
PLY
—to set the track so that it plays back any audio recorded on the track.
•
REC
—to arm the track for recording.
•
MUT
—to turn the track off.
If the AE-7000’s
CLOCK SOURCE is:
This means that
the AE-7000:
Set the VS-2400CD’s
MASTER CLOCK to:
R-BUS derives master clock from the VS-2400CD. a clock source other
than R-BUS.
WORD CLOCK derives its clocking from the word clock
device connected to its rear-panel
WORD CLOCK jack.
R-BUS.
INPUT A uses the master clock received by its
INPUT A jack.
R-BUS.
VS2400OMUS.book 448 ページ ２００６年２月２８日 火曜日 午前１１時１２分
To Next Page
Loading...
