Roland VS-2400CD - Roland MB-24 Notes

Supplemental Information
452 www.RolandUS.com Roland VS-2400CD Owner’s Manual
SURROUND, CH VIEW, MAIN CUE Areas
Roland MB-24 Notes
The optional MB-24 Level Meter Bridge adds a full-sized meter array to your
VS-2400CD. To learn how to connect an MB-24 to your VS-2400CD, see Page 377. “EXT
LEVEL METER (MB-24)” on Page 354 explains how to configure the MB-24 for use with
the VS-2400CD.
The MB-24’s tick indicator—when the TIME DISPLAY
parameter is set to MEASURE/BEAT—shows one-tenth
the actual number of ticks since there are only two digits
available for this purpose, as shown here.
SURROUND Area
VE-7000 knob or button: Acts as CH EDIT parameter or F button:
18. Joystick Surround pan and depth
19. EDIT F2 (Surrnd)
CH VIEW Area
VE-7000 knob or button: Same as CH EDIT parameter or F button:
20. EDIT CH EDIT button—displays CH EDIT VIEW screen
21. SHIFT Performs same function as VS-2400CD SHIFT button
MAIN/CUE Area
VE-7000 knob or button: Same as CH EDIT parameter or F button:
22. PAN PAN
23. ON/OFF MIX on/off switch
24. EDIT (Set CENTER) Displays CH EDIT VIEW screen, PAN selected
Hold SHIFT and press MAIN/CUE EDIT•Set CENTER to set PAN to its C (center)
value.
Hold SHIFT and press MAIN/CUE ON/OFF•CH LINK to link or un-link the currently
selected channel with its odd/even partner.
When used with the VS-2400CD, the MB-24 does not use its PRE EQ, SECTION (1st
UNIT/2nd UNIT), MULTI OUT, FLEX BUS, MULTI IN, INPUT, DIM,” or TALKBACK
indicators. Also, you may occasionally notice that PRE EQ and 1st UNIT light
immediately after the MB-24 is turned on. This does not indicate a malfunction.
18
19
20
21
22
24
23
Hold down SHIFT as you
turn a VE-7000 knob to
activate its TURBO EDIT
feature. When TURBO
EDIT is turned on, a knob
scrolls through values in
smaller or larger
increments, depending on
the parameter.
For Measure 25, Beat 3,
Ticks 470-479 are shown
as simply Tick 47.
VS2400OMUS.book 452 ページ ２００６年２月２８日 火曜日 午前１１時１２分