Roland VS-2480 - Applying a Loop Type Effect During Playback

53
Using Effects
Using Effects
Applying a Loop Type Effect During
Playback
It is common to apply a send/return type effect such as reverb or delay during
playback. The following example shows how you can apply reverb (FX1) to track 1
during playback.
fig.04-03_55
1. Press [HOME (DISPLAY)]. Home Condition screen will appear.
2. As described in “Selecting the effect bus assignment (p. 52),” specify
which AUX bus will be used as the effect bus.
3. Press [TR 1-16 (MASTER EDIT)]. [TR 1-16 (MASTER EDIT)]
indicator will light, and [CH EDIT] will be the Track Mixer
channel edit buttons for channels 1–16.
fig.04-04_30000000
4. Hold [STOP] and press track channel 1
[TRACK STATUS]. [TRACK STATUS] will light
green, track channel 1 will be the playback track.
fig.04-05
5. Press [CH EDIT] for the track mixer channel whose effect you wish to use.
For this example, Press channel 1 [CH EDIT]. Mixer Condition screen will
appear.
fig.04-04_30
fig.tr-chview
PA GE F1 F2 F3 F4 F5 F6 HOME
DISPLAY
1
IN 1
-
16
SOLO
FX RTN
IN 17
-
24
AUX MST
TR 17
-
24
TR 1
-
16
FADER
MUTE
MASTER
EDIT
V. FADER
1
+
STOP
SHUT / EJECT
TRACK STATUS / PHRASE PAD
9121
17
2
18
3
19
4
20
5
21
6
22
7
23
8
24
TO
FROM
13 14 15 1610 11
FX 2FX1 FX 3 FX 4 FX 5 FX 6 FX 7 FX 8
AUX 2 AUX1 MST AUX 3 AUX 4 AUX 5 AUX 6 AUX 7 AUX 8
CH EDIT / SELECT / PHRASE SEQ STATUS / AUTOMIX STATUS
WRITE
REA D
MANUAL
RTN
PHRASE
REC
PLAY
OFF
TRACK
PHRASE SEQ
PA D
/AUTOMIX
5