17
Jun. 2001 VS-2480
• Error Ccodes (xx) and Their Meaning
01: Communication error -- Cannot receive the Port/
Code(01).
02: Parity error -- A parity error occurred in SCI.
03: Framing error -- A framing error occurred in SCI.
04: Overrun error -- An overrun error occurred in SCI.
05: Rx buffer full -- Data overflowed the receiving buffer on
the panel.
06: Illegal request -- The contents of the received message
are incorrect.
07: Illegal Flash ROM -- An unknown flash ROM was
detected.
08: FLASH ROM erase block failed -- The erase-block
operation on the flash ROM failed.
09: FLASH ROM write failed -- The write-in operation on
the flash ROM failed.
0A: FLASH ROM check-sum error -- The checksum
calculated in updating the flash ROM is incorrect.
0B: FLASH ROM broken -- The flash ROM was found to be
broken during start-up.
• Error : System Section Error
The system software may be defective.
• RAM Check Error
The SDRAM on the main board has a fault.
• Error : Flash Memory Does Not Exist
Cannot recognize the flash ROM on the main board.
The flash ROM may be defective.
• Error : Flash Memory Erase Error
The contents of the flash ROM cannot be erased.
The flash ROM may be defective.
• Error : Flash Memory Write Error
Cannot write to the flash ROM on the main board.
The flash ROM may be defective.
• Error : Flash Memory Verify Error
A difference was found between the contents of the flash
ROM on the main board and those of the update program.
• Bad Block Detected!
A bad block was found in the IDE hard disk.
• Address Mark Not Found!
ID Not Found!
The disk cannot be read normally.
The contents of the disk may be defective.
• Can't Communicate!
Communicate cannot be made with the IDE or SCSI drive.
The drive may have failed.
• Uncorrectable Data Error!
Message Error!
An error occurred in communication with an SCSI device.
• Track 0 Not Found!
Calibration of the hard-disk drive head failed.
The hard-disk drive has failed or there is a problem with
thermal run-away.
• Arbitration Failed!
Check Condition!
Drive Status Error!
Normal communication with the disk drive failed.
• SCSI Not Available!
The SCSI portion of the main board failed.
• SCSI ID Error!
The SCSI ID numbers of more than one disk drive are
overlapped.
Reset these numbers so that they don't overlap.
• Wait for free BUS!
Another SCSI host controller is connected to the machine.
This error may occur when the VS-2480 is connected to a
personal computer via the SCSI interface.
• Phase Mismatch!
Illegal Phase!
There is an abnormality in the SCSI data line.
• Medium Error!
There is an error in the removable medium.
• Hardware Error!
The SCSI drive has failed.
• Illegal Request!
The VS-2480 cannot use this disk drive.
• No IDE Drive!
The machine has no built-in hard-disk drive.
• IDE Not Available!
No response was received from the IDE drive.
The hard-disk drive has failed or there is a problem with
thermal run-away.
• Unusable Sector!
You are using a medium which has no 525-byte sectors.
• Unknown Drive Error!
There is an error in the drive.
• Lack of IDE Memory!
The built-in IDE hard disk does not have enough free space
to accommodate the image data.
• EMERGENCY Error!
An unrecoverable error has occurred.
• Drive Time-out!
No response was received from the drive.
The hard-disk drive has failed or there is a problem with
thermal run-away.
• !!! Warning !!!
Clock/Calendar Backup Battery Low.
The lithium battery is flat.
• No Drives Found.
[ENTER] to Re-Check the Drives.
Cannot recognize any built-in or external drives.
• No Formatted Drives Found.
Jump to Force Initialize Drive.
The drive connected has not been formatted.
• Too Complicated Error!
Can't Recover Drive!!
There is an error in the removable medium.
• Drive Not Formatted!
Make Partition!
The hard disk or the removable disk has not been formatted.
• Blank Disk!
You are trying to execute the CD player function on a CD-R
disk which does not contain any performance data.
Insert CD software you bought on the market or another CD-
R disk which contains.
• TOC Error!
TOC Read Error!
Reading from the CD-R disk failed.
The CD-R drive or disk has an abnormality.
• No CD-R Drive!
Cannot recognize the CD-R drive.
To Next Page
Loading...
