Roland VS-2480 - The VGA Input Clipping Indicators; VGA F Buttons; Status Strip

4—VGA Main Display Universal Elements
Roland VS-2480 Owner’s Manual, Version Two Addendum www.RolandUS.com 33
• Aux send levels—press the KNOB FADER ASSIGN/AUX SEND 1-8 button on the
VS-2480 and press the Aux bus’s number on the keypad.
• a parameter of your choice—press the KNOB FADER ASSIGN/AUX SEND 1-8 button
on the VS-2480 and press 9 on the keypad.
The VGA Input Clipping Indicators
The VGA main display’s input clipping indicators light when an input
channel’s analog input signal is too loud. The INPUT PEAK LEVEL
parameter sets the level at which they light—see Owner’s Manual 362.
VGA F Buttons
Status Strip
The status strip contains flashing indicators that signal the activation of certain features
and modes that might not otherwise be visually obvious.
The F buttons beneath the VGA main display’s content pane (Page 21)
mirror the current behavior of the F buttons beneath the VS-2480’s
internal LCD, as does its PAGE button. You can click the VGA’s F buttons
or the LCD’s at any time with the same results.
PAGE shows the number of screens associated with the current display.
You can move from page to page by pressing  and .
If you prefer, press F1-F6 on a connected ASCII keyboard instead of clicking with your
mouse or pressing the VS-2480’s physical F buttons. Use Tab as your PAGE button.
When: The status display flashes:
one or more channels are soloed “SOLO” in blue
one or more channels are muted “MUTE” in yellow
Mastering Room playback is turned on “MASTERING PLAY” in green
Mastering Room recording is turned on “MASTERING REC” in red
phrase sequencer recording is turned on “PHRASE SEQ REC” in red
Automix recording is turned on “AUTOMIX REC” in red
PAGE
F buttons
66, 67