5—VGA Main Display Home Screen
42 www.RolandUS.com Roland VS-2480 Owner’s Manual, Version Two Addendum
7. PHRASE SEQ STATUS (P) Button
8. TRACK STATUS Button
9. FADER (LEV) Slider
10. PAN Slider
11. PHASE Button
12. ATT Slider
13. GROUP (GRP) Selector
14. LINK Switch
When the phrase sequencer is turned on and the track’s phrase pad
is turned on, you can set its phrase sequencer track status by
repeatedly clicking the PHRASE SEQ STATUS button.
You can simultaneously set the phrase sequencer status of all of your tracks by
repeatedly clicking the Phrase Sequencer status toggle button. See Page 44.
Click a TRACK STATUS button repeatedly to set its track’s status—
this is the same as pressing the corresponding physical TRACK
STATUS button on the VS-2480.
Drag the FADER slider to set the track channel’s CH EDIT FADER
parameter—this serves the same purpose as moving the channel’s
physical fader. The readout to the right of the slider shows the track
channel’s output level in dB.
Adjust the track channel’s stereo position by dragging the PAN
slider as desired—the current pan position is shown to the right of
the slider. When you move the slider, you’re adjusting the track
channel’s CH EDIT PAN parameter value.
Click “NRM” or INV” in the PHASE button to reverse the phase
polarity of the track channel’s signal.
Set the ATT slider to adjust the level of the signal coming from the
hard disk recorder into the track channel. The signal’s level is shown
to the right of the slider.
To assign the track channel to a fader group, click to the right of
“GRP” and select the desired fader group from the pop-up menu.
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of “LINK” and select the desired type of linking from the
pop-up menu or turn off linking.
275
178
154
156
154
153
155
152, 155
To Next Page
Loading...
