Roland VS-2480 - Multi-Channel View Track Channels

7—Mixer Views
74 www.RolandUS.com Roland VS-2480 Owner’s Manual, Version Two Addendum
Multi-Channel View Track Channels
1. V-Track Selector
2. PHASE (INV) Button
3. ATT Knob
4. DYNAMICS (DYN) Switch and Overview
5. EQ Switch and Overview
6. AUX Send Sliders
7. DIR (DIRECT) 1-8 Buttons
8. MUTE (M) Button
Click the V-Track signal selector to assign the
desired V-Track to the track channel.
Click the PHASE button so it lights to reverse the
phase polarity of the input channel’s signal.
Drag the ATT slider to adjust the level of the
signal coming into the channel. The signal’s level
is shown to the left of the knob.
Turn on the channel’s dynamics processor by clicking the DYN
switch so it lights. The currently selected type of dynamics
processor is shown beneath the switch along with the current
dynamics curve.
Turn on the channel’s EQ by clicking the EQ switch so it lights. The
current EQ curve appears below the switch.
Set the amount of the channel’s signal sent to an Aux bus by adjusting
the corresponding AUX send slider. With linked Aux busses, a panning
handle replaces the even-numbered Aux bus’s slider (Page 67).
To route the channel’s signal to a Direct bus, click the desired bus’s
number.
To mute the channel, click this button so it’s lit. To un-mute the channel,
click the button again.
1.
4.
12.
13.
15.
16.
5.
7.
2.
3.
6.
8.
10.
14.
11.
9.
151
154
153
153
153
152
156
142