26 ©2001 Roland Corporation US VS-2480 Tip Sheet
only Effect 1 and 2 are available.) By default, FX 1 controls the return from Effect 1,
FX 2 controls Effect 2’s and so on.
2. Press the CH EDIT button for the FX channel that corresponds to an effect you want to
send to the headphone mix. The FX channel parameters appear.
3. Use ", #, $ and/or %, if necessary, to select the On/Off switch for the send to the Aux
bus you’re using for your headphone mix.
4. Turn the TIME/VALUE dial to turn the Aux send on.
5. Press % to select the send level.
6. Turn the TIME/VALUE dial to set the amount of the effect to be sent to the
headphone mix.
If you’re using a linked pair of Aux busses for a stereo headphone feed, you can still
send the effect to the headphones using the method described above.
You can send one effect into another using the Aux send controls on this screen.
You can also set the send level using the PAN/AUX SEND 1-8 knobs—see “Sending
Channel Signals to an Aux Bus” on Page 19. (You’ll still, however, need to activate the
Aux send on this screen.)
To Next Page
Loading...
