23
Objects shown in the VGA display
TRACK ASSIGN area
1. INPUT MIXER
2. AUX BUS
3. DIR PATH
4. RECORDING TRACK
This is where you will actually record audio. Recording is possible when
you have assigned (connected) each recording track to an audio source.
Assignments can be made by dragging a connection point of the input
mixer or track mixer.
5. TRACK MIXER
6. EFFECT RETURN MIXER
7. GENERATOR
OUTPUT ASSIGN area
1. OUTPUT Connectors
2. Recording Bus Attenuator
3. MASTER BUS
4. MONITOR BUS
5. Recording BUS
6. AUX BUS
7. DIR PATH
8. TRACK DIRECT OUT switch
When track direct out is “ON,” the audio from the track mixer channels
will be connected to the output jacks.
9. TRACK DIRECT SOURCE PRE/POST switching
10. TRACK MIXER
LOOP EFFECT ASSIGN area
1. AUX BUS
2. DIR PATH
3. Source Signal selector
You can drag this connection point to select the signal that will
be input to the effect.
4. Effect Patch Number
It is not possible to connect
the identical channel of the
track mixer and recording
track.
1
2
3
4
5
6
7
9
10
8
1
2
4
3
To Next Page
Loading...
