Roland VS-640i - Printing with White and Cmyklclm Ink

34
Chapter 3 Printing Chapter 3 Printing
3-2 Print Job Setting : Equipped with White & Silver

Click .
In [Operation Mode], select the operation
of the printer.

Click [OK] to close the "Queue A Proper-
ties" window.
This is the end of the print job setting. To start printing, go on to P. 51, "Starting the Print Operation".
* Only the settings necessary for the use of the white ink are described in this section. For other settings, refer
to the online help provided for VersaWorks.
Printing with White and CMYKLcLm Ink
This section describes how to perform printing with the white ink and the CMYKLcLm ink. Deciding which
ink between the white and the CMYKLcLm you want to use for the base is an important point in determining
the print job setting here. To use the white ink for printing, you need to use the printing data where the use
of the white ink is designated.
 P. 12, "2-3 Creating Printing Data"
Procedure

Make sure that you have nished making the preparations for VersaWorks, getting the
printer ready, and creating the printing data ( P. 9, "Chapter 2 Getting Ready").

Double-click .
"Queue A Properties" window appears.
VS-640i_USE2_EN_R1.indb 34 2013/07/23 19:00:28